Haier HB3600VC1M25 Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Pompy ciepła Haier HB3600VC1M25. Haier HB3600VC1M25 User's Manual Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 15
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
10 to 12 SEER 3 to 5 Tons
HB3600VC1M25 HB4200VA1M25
Installation & Operation Manual
Air Handler
HB6000VA1M25
HB6000VC1M25
HB4800VA1M25
WARNING
WHEN THIS APPLIANCE IS INSTALLED IN AN ENCLOSED AREA, SUCH AS
A GARAGE OR UTILITY ROOM, WITH ANY CARBON MONOXIDE PRODUCING
DEVICES (i.e. AUTOMOBILE, SPACE HEATER, WATER HEATER,ETC.) INSURE
THAT THE ENCLOSED AREA IS PROPERLY VENTILATED.
WARNING
CARBON MONOXIDE (REFERED TO AS CO) CAN CAUSE PERSONAL INJURY
OR DEATH
WARNING
FAILURE TO FOLLOW THESE INSTRUCTIONS, LOCAL CODES OR NATIONAL
CODES MAY CAUSE FIRE, EXPLOSION, ELECTRICAL SHOCK, PERSONAL
INJURY OR PROPERTY DAMAGE.
FOLLOW ALL LOCAL CODES. IN THE ABSENCE OF LOCAL CODES REFER TO :
NATIONAL ELECTRICAL CODE NFPA 70
NFPA 90A & 90B
UNIFORM MECHANICAL CODE
READ THESE INSTRUCTIONS COMPLETELY BEFORE ATTEMPTING TO INSTALL
OR SERVICE THIS APPLIANCE.
ONLY FACTORY AUTHORIZED KITS OR ACCESSORIES SHOULD BE USED WHEN
INSTALLING OR MODIFYING THIS APPLIANCE, UNLESS OTHERWISE NOTED IN
THESE INSTRUCTIONS.
SOME LOCALITIES MAY REQUIRE THE INSTALLER/SERVICER TO BE LICENSED.
IF IN DOUBT CONTACT YOUR LOCAL AUTHORITIES.
These instructions should be retained and kept adjacent to the unit for future reference.
MODEL # HB 00VA1M25
MODEL # HB 00VC1M25
INSTALLATION DATE
The information contained in this booklet is subject to change without notice.
No. 0010575351
E
Models:
Przeglądanie stron 0
1 2 3 4 5 6 ... 14 15

Podsumowanie treści

Strona 1 - Air Handler

10 to 12 SEER 3 to 5 TonsHB3600VC1M25 HB4200VA1M25 Installation & Operation Manual Air Handler HB6000VA1M25 HB6000VC1M25 HB4800VA1M25W

Strona 2

THERMOSTAT WIRING10For Thermostat Control Environment-temperature and Air Conditioning open/stop, the wiringdiagram as shown diagram 1. Thermostat can

Strona 3

11For Thermostat Control Environment-temperature and Air Conditioning open/stop, the wiringdiagram as shown diagram 4. Thermostat can be mechanical ty

Strona 4

SEAL CAP13/16 NUTTAIL PIECEWHITE TEFLON SEALPISTONSUCTION LINEWITH SPINCLOSURERUBBERGROMMETORIFICE CHANGEThe restrictor (orifice) included in this un

Strona 5

BLOWER PERFORMANCECFM versus Static Pressure (inches of water column dry coil w/ filter) 4% reduction for wet coil.The air delivery can be varied by c

Strona 6 - Primary Knockout

START-UPPrior to initial start-up insure that all electrical connections are properly sized and tightened.All panels must be in place and secured.Tubi

Strona 8

INDEXTOPIC PAGEGeneralPhysical dimensionsReplacement Parts SourceInstallation RequirementsAir Flow OrientationHorizontal Left-Hand InstructionsDownflo

Strona 9

DCPRIMARY & SECONDARYCONDENSATE DRAINS-HORIZONTAL 3/4" NPT 2"[5.08 cm] 5.1"[13 cm] 2"[5.08 cm]TYPICALFKG 1.1"

Strona 10 - THERMOSTAT WIRING

REPLACEMENT PARTS SOURCEReplacement parts are available through local distributors.When ordering replacement parts, givethe COMPLETE model and seria

Strona 11 - TRANSFORMER

AIR FLOW ORIENTATIONDownflow discharge(with plastic verticalpan only) (see page 7)*Horizontal Right Discharge Tube and Drain conn. frontHorizontal

Strona 12 - CIRCULATING AIR DUCT

HORIZONTAL LEFT-HAND INSTRUCTIONSImportant: Read instructions below carefully.1) With Airhandler in the vertical position, remove all three access

Strona 13 - HB3600VC1M25

DOWNFLOW INSTRUCTIONSImportant: Read instructions below carefully1.Before putting the Air Handler in the downflow position, remove the three access p

Strona 14

REFRIGERANT TUBINGCONDENSATE REMOVALRefrigerant tubing should be installed as to avoid undue stress. They must be supported orrouted to avoid strain o

Strona 15

ELECTRICAL CONNECTIONSThe required electrical power supply information is located on the series and rating plateon the exterior of the unit. Wiring se

Komentarze do niniejszej Instrukcji

Brak uwag